Adjusting The Picture Position; Adjusting The Pixels - Sony FWD-50PX1 Manual De Instrucciones

Resizing and Positioning the Picture

Adjusting the Picture Position

1
In the Screen Control menu, press M/m to move
the cursor (yellow) to "Screen Shift" and press
ENTER.
The following menu appears on the display panel.
H S h i f t
V S h i f t
2
The M/m/</, buttons move the picture
vertically and horizontally.
</, : Move the picture left and right
M/m : Move the picture up and down
Horizontal picture position is displayed on the
screen with adjustment values ranging from LEFT
(128) to RIGHT (127). Vertical picture position is
displayed on the screen with adjustment values
ranging from BOTTOM (128) to TOP (127). The
factory preset value is 00.
3
Press ENTER.
The menu returns to the Screen Control menu.
36
(GB)
0 0
0 0

Adjusting the Pixels

If there is too much noise on the edges of the
characters or the vertical lines, you can adjust the dot
phase and the total number of horizontal pixels.
Note
This item depends on the computer signal being used.
1
In the Screen Control menu, press M/m to move
the cursor (yellow) to "Adjust Pixel" and press
ENTER.
The following menu appears on the display panel.
S c r e e n C o n t r o l
A d j u s t P i x e l
A u t o A d j u s t
D o t P h a s e
T o t a l H
R e s e t
, t o s e l e c t ,
s e t
2
You can adjust the dot phase and the total number
of horizontal pixels automatically or manually.
Adjusting automatically
(1) Select "Auto Adjust" with M/m and press
ENTER.
The following menu appears on the display
panel.
S c r e e n
A d j u s t
A u t o
D o t P h a s e
T o t a l
R e s e t
, t o
t o r e t u r n
(2) Select "OK" with M/m and press ENTER.
The dot phase and the total number of
horizontal pixels are adjusted automatically.
P i x e l : 1 3 4 4
, t o
ENTER
C o n t r o l
P i x e l
A d j u s t
C a n c e l
O K
H P i x e l : 1 3 4 4
s e l e c t , p r e s s
ENTER