Motor Brushes - DeWalt DWP849 Manual De Instrucciones

making any adjustments or removing/installing attachments or
accessories. Before reconnecting the tool, depress and release
the trigger switch to ensure that the tool is off.
Cleaning
WARNING: Blow dirt and dust out of all air vents with dry air at
least once a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye
protection and proper NIOSH/OSHA/MSHA respiratory protection
when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
Lubrication
D WALT tools are properly lubricated at the factory and are ready
e
for use. Tools should be relubricated regularly every sixty days to six
months, depending on usage. (Tools used constantly on production or
heavy-duty jobs and tools exposed to heat may require more frequent
lubrication.) This lubrication should only be attempted by trained
power tool repairpersons such as those at D
other authorized service locations.

Motor Brushes

Be sure tool is unplugged before inspecting brushes. Carbon brushes
should be regularly inspected for wear. To inspect brushes, unscrew
the plastic brush inspection caps (located in the sides of the motor
housing) so the spring and brush assemblies may be withdrawn from
the tool. Keep brushes clean and sliding freely in their guides. Carbon
brushes have varying symbols stamped into them, and if the brushes
are worn down to the line closest to the spring, they must be replaced.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call
1-800-4-D
com.
Use only accessories having a maximum operating speed at least as
high as the highest "NO LOAD RPM" marked on the tool's nameplate.
This precaution applies to any accessory on any tool.
• Rubber backing pads: 7" (17.8 cm) Quick Change Super
Flexible Rubber Backing Pad
(includes clamp washer)
• 7" (17.8 cm) hook and loop backing pads
• Soft rubber gear case cover
WALT service centers or
e
• Wool ingestion shields
• Auxiliary handle
• Bale handle
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustments (including brush inspection and replacement) should be
performed by a D
service center or other qualified service personnel. Always use identical
replacement parts.
12
WALT recommended accessories should be used with
e
WALT (1-800-433-9258) or visit our website: www.dewalt.
e
WALT factory service center, a D
e
WALT
e
WALT authorized
e