Sound Settings; Sound Mode - Sony KLH-40X1 Manual De Instrucciones

Sound Settings

: :

Sound Mode

Sound Mode Reset
Treble
Bass
Balance
Common Audio Sel.
Speaker Out
Tip
You can adjust the "Sound" settings ("Treble" and "Bass") when the "Sound Mode" is set to "Custom".
22
GB
: :
"Dynamic": Select to enhance treble and bass.
"Standard": Flat setting.
"SRS WOW": Provides a panoramic stereo audio image by producing deep and rich
bass tones and clear treble tones, enabling you to enjoy powerful sound effects like
those in a movie theater.
"Custom": Allows you to store preferred settings.
Tips
• To change from one "Sound Mode" option to another, you can also use SOUND on the
remote control instead.
• The proprietary technologies of BBE Sound, Inc. are applied for "Dynamic" and "Standard".
Resets the following settings; "Treble", "Bass" and "Balance" to the default settings.
Adjust to increase or decrease higher-pitched sounds.
Adjust to increase or decrease lower-pitched sounds.
Adjust to emphasize left or right speaker balance.
"HD15": Outputs audio from a piece of video equipment or PC connected to the
HD15 (RGB/COMPONENT IN) connector and the AUDIO (COMMON AUDIO
IN) connector.
"HDMI 1"/ "HDMI 2": Select to connect a piece of equipment using an HDMI cable
(not supplied) or an HDMI-to-DVI cable (not supplied), and the corresponding audio
cable at the same time.
See page 10.
Notes
• When using an HDMI-to-DVI cable, connect the audio cable to the AUDIO (COMMON
AUDIO IN) connector.
• When "HDMI 1"/ "HDMI 2" is selected, digital audio is not output from the HDMI
connectors. When a piece of video equipment equipped with an HDMI connector is
connected to the HDMI 1/HDMI 2 connectors, set "Common Audio Sel." to "HD15". (The
default setting is "HD15".)
"On": Enables sound to be emitted from the display speaker.
"Off": Disables sound to be emitted from the display speaker.
Note
When "Speaker Out" is set to "Off", "Sound Mode", "Sound Mode Reset", "Treble", "Bass",
and "Balance" cannot be selected.
To highlight an option and to change settings, press
F f G g
/ / / .
Press to confirm the selection.
The "Sound" settings include the following options: