Description Of The Product; Elements Of The Complete Installation - Erreka TOPO Manual Del Instalador

DESCRIPTION OF THE PRODUCT

1

ELEMENTS OF THE COMPLETE INSTALLATION

TA
INSTALLATION COMPONENTS:
1 Operator
2 Flashing lamp
3 Gate
4 Exterior photocells
5 Key selector
6 Wall button
7 Control panel
8 Connections case
9 Underground electrical installation
10 Drainage ducts
11 Interior photocells
12 In-ground central stop
13 Aerial antenna
14 Electrolock
15 Opening external stopper
ELECTRICAL CABLING:
Element
A: General power supply
B: Flashing lamp
C: Photocells (Tx / Rx)
D: Key selector
E: Operator (motor + encoder) H o s e ( 2 x 1 m m
F: Antenna
Fig. 1 Elements of the complete installation

The safe and correct operation of the
installation is the responsibility of the installer.

Only use control panel VIVO-D201(M). We do
not recommend using this operator with control
panels which are not produced by Erreka.
MOTOR
2
2x1mm
ENCODER
2
2x0,5mm
8m
TC
Nº threads x section
2
3x1.5mm
2
2x0.5mm
2 2
2x0.5mm / 4x0.5mm
2
2x0.5mm
2
+ i n t e r i o r
2
screened hose 2x0.5mm )
Coaxial cable 50k (RG-58/U)



The TC stopper must be installed in all
cases.

The TA opening external stopper is
only necessary with the 180º opening
mechanism (chain).
TA
Maximum length
30m
20m
30m
25m
8m (maximum 25m with 2x2.5mm
cable)
5m
The in-ground central stop (12) is an essential
element.
For greater safety, Erreka recommends installing the
photocells (4) and (11).
TOPO underground electromechanical operator
English
2
43