Installation And Adjustment Of The Mechanism And Of The Gate - Erreka TOPO Manual Del Instalador

Position the base box and the ducts
5

INSTALLATION AND ADJUSTMENT OF THE MECHANISM AND OF THE GATE

Option A: opening mechanism up to 110º
Position the motor and the motor arm
1 1
1 Position the base box (1) in the pit, ensuring it is
levelled.
2 Position the drainage ducts (2) from the base box
through to a water outlet, forming a downpipe
which allows correct drainage.

CHECK THAT DRAINAGE IS CORRECT. The
accumulation of water in the base box could
lead to failures and accidents.
3 Position the electrical ducts (3).
4 Check that the pivot (4) is upright and aligned with
the upper hinge (5).

Where appropriate, move the hinge (5) until it is
on the upright.
5 Cement the base box with quick setting cement.

Position caps on the top attachment orifices (6)
in order to preserve them from the cement.
1 Release the screw (1) and remove the bar (2).
2 Position the motor (3) at the rear of the base box,
ensuring the screws located in the base box coincide
with the holes in the frame of the motor.

The figure shows the position of the motor for a
gate which opens in the direction shown in (A). If
the gate opens in the other direction, the motor
would be mounted rotated 180º with regards to the
position drawn.
3 Position the nuts and tighten firmly using a 17 mm
wrench.
4 Position the motor arm (4) on the motor axle (5).

Respect the position shown in the figure.
TOPO underground electromechanical operator
INSTALLATION
51