Maxon C2 Manual De Instrucciones página 16

1. Remove the solid plug from the pump
reservoir (FIG. 16-1). Install breather
plug (Kit item) in pump reservoir.
2. Bolt on main frame cover (FIG. 16-2).
3. Install the two square plastic grommet
nuts (Kit item), for the license plate, into
the square holes on the Liftgate main
frame cover (FIG. 16-2).
4. Install the license plate using two
1/4"-20 self-tapping screws (Kit item)
(FIG. 16-2).
5. Install the license plate lights into the
holes provided. Refer to instruction sheet
M-14-35. Then, connect the license plate
lights to the vehicle's wiring.
6. Install the 3/8" round plastic plugs into
the empty holes in the bottom of the col-
umns.
7. If previously removed, reinstall spare tire.
LIFT CORPORATION Sht. 16 of 36 DSG#
COMPLETE LIFTGATE INSTALLATION
SELF-TAPPING SCREW
(2 PLACES)
M-14-34
BREATHER PLUG
RESERVOIR
INSTALLING VENT PLUG ON
PUMP RESERVOIR
FIG. 16-1
INSTALLING COVER & LICENSE PLATE
(C2 LIFTGATE SHOWN)
FIG. 16-2
Rev. A Date: 03/03/17
PUMP & MOTOR
5/16" HEX NUT,
5/16" FLAT WASHERS
(3 PLACES)
COVER
GROMMET NUT
(2 PLACES)
LICENSE PLATE
(REF)