Maxon C2 Manual De Instrucciones página 5

NOTE: Installer is responsible for ensuring vehicle meets Federal, State, and Local
standards and regulations.
Consult vehicle body manufacturer for vehicle body strength data. Make sure the
forces created by the Liftgate are within the limits prescribed by the vehicle body
manufacturer.
NOTE: Maximum operating bed height for C2 mounted on fl atbed or van truck body is
50" (Unloaded). Minimum bed height is 30" (Loaded). Do not install this lift-
gate on bodies equipped with rear-mounted swing-open doors.
The C2 is a body-mounted liftgate that
put forces on the side walls of truck bod-
ies (FIG. 5-1). For correct installation,
truck bodies must be strong enough to
withstand the tension, compression and
shear forces shown in FIG. 5-1.
LIFT CORPORATION Sht. 5 of 36 DSG#
BODY STRENGTH
!
Y= 2600 LB
WARNING
X= Tension on each sidewall
Y= Compression on each sidewall
Z= Shear on each sidewall
Z= 2000 LB
BED HEIGHT
C2 LIFTGATE SHOWN ON TRUCK BODY
M-14-34
Rev. A Date: 03/03/17
X= 2600 LB
FIG. 5-1