Publicidad
Idiomas disponibles
Idiomas disponibles
STRUCTURAL REQUIREMENTS
The total weight of the hood is 63 lbs as supplied and 82 lbs when the ducted flue
kit is used. Special structural considerations must be made to ensure proper instal-
lation. The mounting brackets need to be mounted to 2" nominal lumber. Hollow wall
anchors of any kind should not be used. Fig. 8.
ROUGH-IN DETAILS
Possible incoming
power locations
Control Panel Side
ROUGH-IN ELECTRICAL
This hood is hard wired via a junction box located in the hood canopy. Incoming
power should be located as shown on the drawings above.
WARNING: Electrical wiring must be done by a qualified person in ac-
cordance with all applicable codes and standards.
8"
1
"
6
4
3
"
2
4
1
1
"
"
8
6
8
4
1
"
22
2
2x4 Cross Brace
2x8 Blocking
must be flush
with ceiling joist
6" Duct
outline
(Ducted only)
1
"
8
4
- 9 -
Ceiling
Joist
FIG. 8
Publicidad
