MAINTENANCE
Proper maintenance of the Downdraft will
assure proper performance of the unit.
BEFORE SERVICING OR CLEANING
UNIT, SWITCH POWER OFF AT SER-
VICE PANEL AND LOCK SERVICE
DISCO-NNECTING MEANS TO PREVENT
POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
WHEN THE SERVICE DISCONNECTING
MEANS CANNOT BE LOCKED, SECU-
RELY FASTEN A PROMINENT WARNING
DEVICE, SUCH AS A TAG, TO THE SER-
VICE PANEL.
Grease fi lters
The grease fi lters should be cleaned perio-
dically depending upon use (approximately
every (1) month).
Use a warm detergent solution. Grease fi lters
are dishwasher safe.
the dishwasher or sink using a non-phosphate
detergent. Discoloration of the fi lter may occur
if using phosphate detergent or as a result of
local water conditions — but this will not affect
fi lter performance. This discoloration is not
covered by the warranty.
To remove the grease fi lter, push the retainer
near the handle inwards and pull the fi lter
upwards (Fig. 19).
Cleaning liquid waste pan
The appliance is equipped with a removable
oil pan that will collect oil, grease and con-
densation from cooking. Remove the pan (Fig.20), keeping it in horizontal position,
and clean it with a neutral cleaning agent. This should be cleaned regularly, as
needed, every month.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will
help preserve its fi ne appearance.
Cleaning tips:
• Hot water with soap or detergent is all that is usually needed.
• Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth
to avoid water marks.
• For discolorations or deposits that persist, use a non-scratching household
cleanser or stainless steel polishing powder with a little water and a soft cloth.
• For stubborn cases, use a plastic scouring pad or soft bristle brush together with
cleanser and water. Rub lightly in direction of polishing lines or "grain" of the
stainless fi nish. Avoid using too much pressure which may mar the surface.
• DO NOT allow deposits to remain for long periods of time.
• DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
to the surface causing rust.
• DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
contact stainless steel. Many of these compounds contain chemicals which may
be harmful. Rinse with water after exposure and wipe dry with a clean cloth.
• DO NOT use bleach ever!
• Surfaces should be cleaned with warm water and mild detergent only.
Clean all-metal fi lters in
- 12 -
FIGURE 19
FIGURE 20