Husqvarna PG 820 RC Manual De Instrucciones página 41

Fault
Message on the display
Code
0x010362
0x010363
0x010367
0x010368
0x010369
Grinding disc driver error, contact service if error
persists!
0x01036C
0x01036D
0x010374
0x010375
0x010376
Planetary head driver error, contact service if error
0x010400
persists!
0x010441 Motor overload, contact service if problem persists! Too high motor current
Planetary head driver error, contact service if error
0x010442
persists!
0x010443 Internal error, contact service!
Planetary head driver error, contact service if error
0x010448
persists!
0x010449 Input voltage is too low!
0x01044B Planetary head driver error, contact service!
0x01044D Temperature in machine is too low!
0x01044E Temperature in machine is too high!
0x010450 Motor overload, contact service if problem persists! Too high motor temperature
0x010456
0x010459
0x010462
0x010463
0x010467
0x010468
Planetary head driver error, contact service if error
persists!
0x010469
0x01046C
0x01046D
0x010474
0x010475
0x010476
Machine or remote control needs software update,
0x020424
contact service!
0x02000F Temperature in remote control is too high!
0x02041F Internal error in remote control, contact service!
The clock has stopped, please correct it if
0x020441
neccessary.
TROUBLESHOOTING
Cause
VFD internal error
Too high VFD temperature
VFD internal error
VFD communication fault
VFD internal error
General error
Too high DC-link voltage
Sum of motor phase current is not zero.
VFD internal error
Too low DC-link voltage
At least one phase without current
Too low VFD temperature
Too high VFD temperature
VFD internal error
Too high VFD temperature
VFD internal error
VFD communication fault
VFD internal error
Could not communicate with remote device
High temperature in remote control.
Flash/fram memory could not be read
Remote lost real time clock
–
English 41