To Adjust The Tension Of The Recoil Spring; To Remove The Spring Assembly; To Clean The Spring Assembly - Husqvarna K 770 Manual Del Usuario

To adjust the tension of the recoil
spring
1. Pull out the starter rope.
2. Hold the starter rope pulley (A) with your thumb.
B
A
C
3. Put the starter rope in the notch (B) and wind it up
around the metal sleeve (C).
4. Pull out the starter rope (A).
A
5. Put your thumb on the starter pulley (B) to keep the
starter rope pulled out.
30
B
6. Release the starter rope from the notch.
7. Remove your thumb to release the starter pulley (A)
and let the starter rope (B) wind up on the pulley.
8. Pull out the starter rope fully to do a check that the
recoil spring is not at its end position. Make sure that
the starter pulley can be turned half a turn or more
before the recoil spring stops the movements.

To remove the spring assembly

WARNING: Always use eye protection when
you remove the spring assembly. There is a
risk for eye injury, especially if a spring is
broken.
1. Remove the 2 screws on the spring assembly.
2. Push the 2 brackets on the snap locks with a
screwdriver.

To clean the spring assembly

CAUTION: Do not remove the spring from
the assembly.
1. Blow the spring with compressed air until it is clean.
B
A
1447 - 001 - 16.04.2020