auna Kentucky 10033772 Manual De Instrucciones página 28

EN
Setting the time
When the Jukebox enters standby mode the LCD display panel will
illuminate and the time "00:00" will appear on the LCD display panel.
To set the time, simply press the "PROG" button on the control panel or
remote control (No. 4 on the control panel diagram or No. 6 on the remote
control diagram) and hold this button down for 3 -5 seconds, until "12-H" is
displayed on the screen ("12-H" indicates that the time will be set in 12 hour
format). Then, press  or  you can choose between the 12 or 24 hour
format. Once "12-H" is displayed on the screen press the "PROG" button
again. The display will revert to "00:00" on the display, however, with the
"12" flashing.
Use the  or  buttons on the control panel or on the remote control (No.
3 and 6 on the control panel diagram or remote control diagram), to select
the correct hour (keep in mind it will be set it 12 hour time). Then press the
"PROG" button to confirm. The second "00" will now flash.
Use the " or  buttons to select the correct minutes. Rhen press the
"PROG" button to lock this figure in.
28