To Lubricate The Product; To Replace The Oil In The Gearbox - Husqvarna FS5000 D Manual Del Usuario

To lubricate the product

1. Clean the 8 grease nipples.
2. Replace broken or blocked grease nipples.
3. Lubricate the front wheels.
4. Lubricate the pivot bearings of the front axle.
5. Lubricate the blade shaft. Push the grease pump 2
times at each end of the blade shaft.
6. Lubricate the pivot pin on the hydraulic cylinder.
7. Lubricate the rear axle bearing.
For more information about lubrication, refer to
Technical data on page 42 .

To replace the oil in the gearbox

There are 2 alternatives for how to drain the oil from the
gearbox.
1. To drain the oil with a manual oil pump, do this
procedure:
34
a) Remove the plug in the inspection window at the
front of the product.
b) Use an oil pump to drain the oil through the
inspection window.
2. Remove the left screw.
3. To drain the oil through the hole below the engine,
do this procedure:
1143 - 002 - 08.07.2019