To Replace The Engine Oil And Engine Oil Filter; To Clean The Radiator Air Filter - Husqvarna FS5000 D Manual Del Usuario

2. Turn the engine start switch to ignition on position
(A). Do not start the engine.
A
3. Let the fuel pump operate for approximately 15
seconds to increase the pressure in the fuel system.
4. Turn the engine start switch to the stop position (B).
5. Loosen the tap and drain the water from the water
separator into the container.
6. Tighten the tap.
7. Discard the water as chemical waste. Refer to
Disposal on page 41 .
To replace the engine oil and engine oil
filter
1. Put a cover on the battery to prevent oil spill on the
battery.
2. Remove the cap (A) from the oil drain hose for
engine oil.
3. Open the valve and bend the hose down to drain the
engine oil.
4. Remove the engine oil filter (B) and discard it.
5. Close the valve.
6. Fill a new engine oil filter with oil and install the
engine oil filter on the product.
1143 - 002 - 08.07.2019
B
B
7. Open an oil tank cap and fill the system with engine
oil. Refer to
Note: There are 2 oil tank caps for engine oil.

To clean the radiator air filter

A
CAUTION: Do not operate the product
without the radiator air filter installed.
• Clean the radiator air filter with soap and water.
• Always replace a damaged radiator air filter.
Technical data on page 42 .
31