RIDGID R4210 Manual Del Operador página 21

ASSEMBLY
 Using a 10 mm combination wrench and a flat head
screwdriver, hold the miter lock screw in place and loosen
the miter lock nut.
 Turn the miter lock screw clockwise to lower the lever.
 Turn the miter lock screw counterclockwise to raise the lever.
 Continue to adjust the lock lever until it is parallel with the
miter table.
 Hold the screw in place and tighten the lock nut securely.
NOTE: Many of the illustrations in this manual show only
portions of the miter saw. This is intentional so that we can
clearly show points being made in the illustrations. Never
operate the saw without all guards securely in place and
in good operating condition.
SQUARING THE SAW BLADE TO THE FENCE
See Figures 20 - 24.
 Unplug the saw.
 Pull the saw arm all the way down and lock in transport
position.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the saw at the 0º bevel angle, engage the bevel detent
lever, and ensure the saw engages the detent.
 Tighten the bevel lock knob.
 Lift the miter lock lever to unlock the miter table.
SLIDING
MITER
FENCE
FIXED
MITER
FENCE
FRAMING
SQUARE
 Press the miter detent button and rotate the miter table
until the pointer on the miter scale is positioned at 0°.
 Release the miter detent button and allow the miter table
to engage the 0° detent position.
 Push the miter lock lever down to lock the miter table.
 Lay a framing square flat on the miter table. Place one
leg of the square against the fixed fence. Slide the other
leg of the square against the flat part of the saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 20.
 If the front or back edge of the saw blade angles
away from the square as shown in figures 22 and 23,
adjustments are needed.
 Rotate the extension tables to their fully extended
position. See To Make Extended Miter Cuts later in this
manual.
 Lift the miter lock lever to unlock the miter table.
 Press the miter detent bypass button. Rotate the miter
table until the pointer is at the left 15° position on the
miter scale.
 Using a 4 mm hex key, loosen the 5 screws that hold the
miter scale/detent plate in place.
 Rotate the miter scale to the 0° position on the miter scale
and detent engages in the detent plate.
BLADE
MITER DETENT
BYPASS
BUTTON
MITER
TABLE
MITER
LOCK
LEVER
21 - English
MITER SCALE/DETENT PLATE
SCREWS
SCREWS
Fig. 20