RIDGID R4210 Manual Del Operador página 23

ASSEMBLY
SQUARING THE BLADE TO THE MITER TABLE
See Figures 25 - 27
 Unplug the saw.
 Pull the saw arm all the way down and lock in transport
position.
 Lift the miter lock lever to unlock the miter table.
 Press the miter detent bypass half way and rotate the miter
table until the pointer on the miter scale is positioned at
0°.
 Release the miter detent bypass and allow the miter table
to engage the 0° detent position.
 Push the miter lock lever down to lock the miter table.
 Loosen the bevel lock knob and disengage the bevel
detent lever.
 Set the saw at the 0º bevel angle, engage the bevel detent
lever and ensure the saw engages the detent.
 Tighten the bevel lock knob.
 Place a combination square against the miter table and
the flat part of the saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
BEVEL
LOCK
KNOB
SLIDING
MITER
FENCE
COMBINATION
SQUARE
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
MITER
TABLE
MITER
LOCK
LEVER
Fig. 25
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 25.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 26 and 27, adjustments
are needed.
COMBINATION
SQUARE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
BLADE
COMBINATION
SQUARE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
23 - English
ADJUSTMENTS ARE REQUIRED
ADJUSTMENTS ARE REQUIRED
Fig. 26
Fig. 27