Controller Components - Toro Custom Command 36 Station Manual Del Usaurio

CONTROLLER COMPONENTS

F
IGURE
1 LCD Display: For viewing time, program and status information.
2 + /On & – /Off Buttons: For entry of program information.
3 Next Button: For selection of information to be programmed or reviewed.
4 Function Dial: For selecting the programming and operating functions.
5 Current Time & Date: For setting the current time and date.
6 Latch Knobs: Quick-release latches for hinged TM control panel.
7 Station Times: For setting individual watering time for each station.
8 Program Select Switch: For selection of programs A, B, C or D.
9 Program Start Times: For setting the time each program cycle will start.
10 Watering Days: For setting a watering day schedule for each program.
11 % Season Adjust/Program Stacking(dual function): For the increase or
decrease of station times for all stations within a program without changing
program memory (% Season Adjust). To the set number of programs (1–4)
which can operate simultaneously. Remote Radio Communication is also
enabled or disabled in this function.
12 Sensor Control Switch: To override rain switch sensor input.
13 Program Erase: For erasing information within a selected program.
14 Manual Program Cycle: For manual operation start of a selected program
watering cycle.
15 Manual Single Station: For timed or untimed operation of a single
station.
16 Off / Rain Delay: For immediate shut down of all controller output.
Programmable output delay for 1–7 days (Rain Delay).
17 Run: For automatic operation.
F
IGURE
18 Remote Port: Connection port for optional remote control receiver.
19 Spare Fuse Holder: Holds a 2.0A slow-blow spare fuse.
20 Valve Common Terminals: For the connection of up to four field (24V)
common wires.
21 Valve Wire Terminals: For the connection of valve control wires.
22 Earth Ground Lugs: For connection of a 6 AWG (10 mm
ground wire(s).
23 Terminal Strip: For the connection of 120 or 230–240 V a.c. power wiring.
24 Master Valve Terminal: For the connection of a master valve or pump
start relay control wire.
25 Sensor Connection Terminals: For the connection an optional normally-
closed Toro rain switch device.
26 Hot Post: 24 V a.c. output for valve zone identification.
27 Battery Compartment: 9-volt alkaline battery access compartment.
28 Safety Fuse: Replaceable 2.0A slow-blow fuse provides protection from
2
an internal short-circuit condition.
1
2
) copper
2