How The Sensor Feature Works; Remote Radio Communication Feature - Toro Custom Command 36 Station Manual Del Usaurio

HOW THE RAIN SENSOR
FEATURE WORKS
The Custom Command is equipped to operate with an optional rain
sensing device, commonly called a "Rain Switch," to prevent
automatic watering during rain.
The rain switch is a simple device, typically installed on a roof
overhang or stationary structure exposed to rainfall and full sun, and
shielded from irrigation spray.
A two-position Sensor switch (see item 12 on page 3) is provided to
enable you to easily bypass operation of the rain switch at any time. If
you choose to disregard rain switch input, place the switch in
SENSOR
the position. To enable rain switch operation, place the Sensor
Bypass
switch in the position. When the dial is in the position,
Active Run
SEN will be flashing if the sensor switch is open.
Note: A jumper wire is installed across the sensor terminals. The
jumper must be removed when the rain switch wires are connected.
See page 23 for sensor installation procedure.
REMOTE RADIO
COMMUNICATION FEATURE
The Custom Command controller is equipped with a remote port to
operate an optional radio receiver, CC-Remote kit or Uni-Remote Kit,
to enable remote radio communication.
To enable or disable remote radio communication:
1. Turn the dial to % Season Adjust/Program Stacking position.
2. Press the Next button until R-ON, R-OFF or R-CEN is displayed.
3. Press either the + /On or the – /Off button to toggle from
R-ON (enable) or R-OFF (disable).
Note: R-CEN (central) is an optional control feature not used for
remote radio operation and should not be selected in the display.
Automatic controller operation will be disabled with R-CEN selected.
4. Turn the dial to the Run position.
6
General Information