Machine Start And Stop; Machine Operation (Scrubbing/Drying) - Nilfisk-Advance Adfinity 17ST Instrucciones De Uso

Squeegee installation
1. Install the squeegee (25) and fasten it with the handwheels (26), then connect the vacuum hose (15) to the squeegee.
2. With the handwheel (27), adjust the squeegee so that the rear blade - in all its length - touches the floor and the front blade
is slightly detached from the floor.
Solution or washing water tank filling
1. Use the filler neck (37) to fill the tank (20) with a solution suitable for the work to be carried out.
Do not fill the solution tank completely, leave few inches from the edge.
Always follow the dilution instructions on the label of the chemical product used to create the solution.
The solution temperature must not exceed +104°F (+40°C).
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Press the switch (71) and/or (73) to turn the machine on.
3. Check that the green warning light (76a) turns on (charged batteries).
If the yellow or red warning light (76b) or (76c) turns on, turn off the machine by pressing the switch (71) and/or (73), then
charge the batteries (see the procedure in the Maintenance chapter).
4. Drive the machine by pushing it with the hands on the handlebar (2).
5. Lower the squeegee (25) with the lever (10).
6. Lower the brush/pad-holder deck by pressing the pedal (11).
7. Press the brush/pad-holder and vacuum system switch (71).
8. Press the washing water flow control switches (77) as necessary, depending on the type of cleaning to be carried out.
Stopping the machine
9. Stop the machine with the handlebar (2).
10. Turn off the brushes/pad-holders and the vacuum system by pressing the switches (71) and (73).
11. Lift the brush/pad-holder deck by pressing the pedal (11).
12. Lift the squeegee (25) with the lever (10).
13. Make sure that the machine cannot move independently.

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. If necessary, press the washing water flow control switches (77) as necessary, depending on the type of cleaning to be
carried out.
3. If necessary, stop the machine and adjust the squeegee balancing handwheel (27).
CAUTION!
To avoid any damage to the floor surface, turn off the brush/pad-holder when the machine stops in one
place, especially when the extra pressure function is on.
Battery discharge during operation
4. Until the green warning light (76a) stays on, the batteries allow the machine to work normally.
When the green warning light (76a) turns off, and the yellow warning light (76b) turns on, it is advisable to charge the
batteries, because the residual autonomy will last for a few minutes (depending on battery characteristics and work to be
performed).
When the red warning light (76c) turns on the machine autonomy is over. After a few seconds brushes/pad-holders are
automatically stopped, while the vacuum system stays on.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery
life.
9096912000(1)2006-09
INSTRUCTIONS FOR USE
15