Connecting Antennas; Connecting The Indoor Fm Antenna; Connecting The Am Loop Antenna - Onkyo CBX-300 Manual De Instrucciones

Connecting Antennas

This section explains how to connect the supplied indoor
FM antenna and AM loop antenna, and how to connect
commercially available outdoor FM and AM antennas.
The CBX-300 won't pick up any radio signals without
an antenna connected, so you must connect the antenna
to use the tuner.
FM antenna jack
AM antenna push terminals

Connecting the Indoor FM Antenna

The supplied indoor FM antenna is for indoor use only.
1 Attach the FM antenna, as shown.
Insert the plug fully
into the jack.
Once the CBX-300 is ready for use, you'll need to
tune into an FM radio station and adjust the posi-
tion of the FM antenna to achieve the best possi-
ble reception.
2 Use thumbtacks or something similar to
fix the FM antenna into position.
Caution: Be careful that you don't injure yourself
when using thumbtacks.
If you cannot achieve good reception with the supplied
indoor FM antenna, try a commercially available out-
door FM antenna instead (see page 17).
16
En-
Thumbtacks, etc.

Connecting the AM Loop Antenna

The supplied indoor AM loop antenna is for indoor use
only.
1 Assemble the AM loop antenna, inserting
the tabs into the base, as shown.
2
Connect both wires of the AM loop
antenna to the AM push terminals, as
shown.
The antenna's wires are not polarity sensitive, so
they can be connected either way around.
Make sure that the wires are attached securely and
that the push terminals are gripping the bare
wires, not the insulation.
Push Insert wire
Once the CBX-300 is ready for use, you'll need to
tune into an AM radio station and adjust the posi-
tion of the AM antenna to achieve the best possi-
ble reception.
Keep the antenna as far away as possible from the
CBX-300, power cord, and your TV.
If you cannot achieve good reception with the supplied
indoor AM loop antenna, try using it with a commer-
cially available outdoor AM antenna (see page 17).
Release