To Adjust The Handle And The Handlebar; To Connect And Disconnect The Battery; To Connect And Disconnect The Propane Tank - Husqvarna PG 690 Propane Manual Del Usuario

• Servicing position of the handle:

To adjust the handle and the handlebar

WARNING: Be careful when you adjust the
handle and the handlebar. Make sure that
the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
1212 - 003 - 25.05.2020
A
B
4. Loosen the 4 screws (C) on the handlebar.
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.

To connect and disconnect the battery

1. Connect the red cable (+) first and then the black
cable (-). Make sure that the cables are tightly
connected to the battery.
2. Make sure that the strap that holds the battery in
position is correctly installed. The battery cannot
move when the battery is correctly installed.
3. Disconnect the battery in opposite sequence.
To connect and disconnect the propane
tank
CAUTION: Make sure to use the correct
propane tank type. An incorrect propane
tank can cause damage to the product.
Technical data on page 29 .
Refer to
CAUTION: Make sure that the propane tank
is in correct position. Do not use the
propane tank upside down.
If the propane tank is connected and the product is not
in operation, close the propane tank valve.
E
D
15