Using The Quilting Guide; Walking Foot; Using The Quilting Foot; Darning Plate - Brother 885-X06 Manual De Instrucciones

USING ATTACHMENTS AND APPLICATIONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Using the quilting guide

Use the quilting guide to sew parallel stitches that are
equally spaced.
Insert the stem of the quilting guide into
1
the hole at the rear of the walking foot or
presser foot holder.

■ Walking foot

■ Presser foot holder
Adjust the stem of the quilting guide so
2
that the quilting guide aligns with the
seam that has already been sewn.

Using the quilting foot

Stitch
Stitch
Pattern Length
Name
[mm (inch)]
2
Straight
Any
Stitch
The Quilting Foot is useful for darning and
free-motion machine quilting.
43
Stitch Width
Other
[mm (inch)]
2.5 Darning
(3/32) Plate
Follow the steps
1 1
Attach the quilting foot, making sure that
2
part A shown in the illustration is above
the needle clamp screw. Then lower the
presser foot lever and tighten the presser
foot screw.
• Make sure that the needle clamp screw is
firmly tightened.
1
1 Presser foot screw
2 Needle clamp screw
CAUTION
●
Use the oval screwdriver to tighten the
presser foot holder screw securely. If the
screw is loose, the needle may hit the
presser foot and you may be injured.
●
Turn the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the
needle may bend or break.
Put the darning plate on the needle plate.
3
Turn on the machine.
CAUTION
●
Do not turn on the machine while
pressing down the foot controller.
Set the pattern selection dial to the
4
Straight Stitch.
• Before starting to sew, draw the quilting
design on the fabric.
to on page 42.
3
A
2