Festo HMPL Serie Instrucciones De Utilizacion página 30

HMPL-...
4. Turn the capstan nut with a mandrel/
spanner until the desired end position of
the moveable mass is reached. The maxi-
mum end positions of the stop element
must be observed (see rough adjustment).
One turn corresponds to approx. 1 mm
modification to the stroke.
5. Use a mandrel/spanner to hold the posi-
tion of the capstan nut and at the same
time tighten the locking nut again
(tightening torque of locking nut see table
below).
Rated Æ Æ Æ Æ
Hole in capstan nut
Width across flats
Nm
Fig. 28
6. Repeat the settings of points 1 to 5 above for the opposite end position.
7. Turn the groove for the proximity switch slightly inwards. Otherwise the cover
of the housing cannot be fastened.
8. Replace and fasten the cover of the housing.
Start a test run as follows:
S
Check with a test run at low speed to ascertain whether the positioning time T
on the HMPL-... needs to be modified.
The moveable mass should reach the end position safely, but not strike hard
against it.
30
HMPL-12-... HMPL-16-...
2 mm 2.4 mm
10 13
2 Nm 3 Nm
Fig. 26
Fig. 27
HMPL-20-...
2.4 mm
15
5 Nm
Festo HMPL-... 0005NH – English