Precautions For Use - Comeg SOPRO 218 Manual De Usuario

3 Precaution for use
• Only qualified personnel are allowed to use this kind of equipment, after being trained.
• Please read this instruction manual carefully before installing and operating the light
source.
• Before connecting the light source to the mains, check and ensure that the electrical
parameters at your facilities are completely identical with the data specified on the
equipment. The identification refill mentioning the service tension, the electrical
consumption, etc. is located on the rear panel of the device.
Do not open the rear panel of the unit! Service only by authorised personnel!
Never place your eyes in the axis of the light output, neither at the tip of the light cable.
• In order to avoid any risk of burning or electrocution, do not expose this device to rain or
excessive humidity.
• In case any fluid getting into the devices, turn the unit immediately off and remove the plug
from the mains.
• Never leave the power cable fall and never place heavy objects on it. If the power cable is
damaged, immediately disconnect the light source from the mains. Never have it working
with a damaged cable!
• To remove the power cable, handle it by the tip not to damage it. Never draw on the cable
itself.
• The mains plug must be close to the light source and easy to reach.
• Check the ventilation to avoid any overheating of the device: ensure that the minimum
space is 15cm on left, right, and rear side of the unit.
WARNING: NEVER operate the equipment near any inflammable gases.
NEVER place the device close to a heat source or to places exposed to vibrations or
shocks.
• Do not use abrasive / corrosive products to wipe the surface of the light source: only use
cleansers and disinfecting liquids classically used in hospitals. Clean the light source in
accordance with your hospital's standard cleansing procedures.
• This light source and its accessories do not require any specific treatment at the end of
their life.
WARNING! DO NOT PLACE THE DISTAL END OF THE LIGHT GUIDE DIRECTLY ON THE
PATIENT AND/OR ON ANY OTHER FLAMMABLE MATERIALS.
It is advisable to have a second light source available in the operating room to use if an
absence or degradation of performance is observed.
WARNING : Use of accessories, transducers, and cables other than those specified
or supplied by the manufacturer of this device may cause an increase in electromagnetic
emissions or a decrease in the immunity of this device and may cause improper operation.
WARNING : Do not use RF Portable Communication Devices (including peripherals such
as antenna cables and external antennas) closer than 30 cm (12 inches) to any part of the
[APPLIANCE or SYSTEM], including cables specified by the manufacturer. Otherwise, the
performance of these devices may be impaired.
10
CAUTION: HIGH VOLTAGE inside the equipment!