How To Assemble; Handle; Tool Storage; How To Operate - Dirt Devil Ud70095 Manual Del Propietário

HOW TO ASSEMBLE

TOOL REQUIRED: PHILLIPS OR FLAT HEAD SCREWDRIVER
HANDLE ASSEMBLY

TOOL STORAGE

1.
Slide handle piece into slot in the back of Attach tools: Clip the dusting brush into the holster at the side of the
the unit. Insert screws into holes indicated cleaner with bristles facing out. Insert the crevice tool and exten-
and fasten. sion wand into the slots on the side of the cleaner. Clip Turbo Tool
holder onto the front of the cleaner. Insert Turbo Tool onto holder.

HOW TO OPERATE

CORD RELEASE CARPET HEIGHT ADJUSTER
2.
1.
CORD
RELEASE
CARPET
HEIGHT
ADJUSTER
Turn Upper Cord • Lowest setting: for all types of carpet.
Release for easy cord Note: If the cleaner is difficult to push, turn knob to
removal. the next higher setting.
• Higher settings: for very deep pile carpet, where
easier pushing effort is desired, while maintaining
good cleaning performance.
HANDLE RELEASE PEDAL FLOOR CARPET CLEANING
4. 5.
To release handle, push the
press the handle release pedal again to clean
handle release pedal located
under furniture. NOTE: Brushbar could cause
on the lower left side of the
rug fringe area to become tangled within
cleaner.
cleaner. Use caution when vacuuming throw
rugs with fringe.
2.
ON/OFF SWITCH
3.
Settings: For
m a x i m u m
cleaning per-
formance, ON/OFF
PEDAL
the following
carpet height
settings are
recommended:
Plug cord into electrical outlet.
Turn cleaner on by pressing the
on/off pedal located on the lower
back of unit.
USING THE ACCESSORIES
6.
Move the
handle and
adjust it to
the desired
position for
(a) storing
the upright,
(b) operating
the cleaner,
and (c) de-
Cleaner must be in its upright
position to raise brushroll for
use with tools and acces-
sories. Turn carpet height
adjuster to deep pile carpet
setting.
6