Connect Ductwork; Non-Ducted Installation - Best CC45 Manual De Instrucciones

CONNECT DUCTWORK

(DUCTED HOODS ONLY)
1. Use 8" round metal duct to connect
the discharge collar on the hood to
the ductwork above. Refer Figure 16.
2. Use duct tape to make all joints secure
and air tight.
NON-DUCTED
INSTALLATION
(NON-DUCTED HOODS ONLY)
When used in recirculation mode, To
Reduce the Risk of Fire and Shock use
only conversion kit Model ANKCC45.
1. Install the adapter on the air outlet. Refer
Figure 17.
2. Refer to Figure 18. Connect 6" round
duct to the discharge opening so that
the air is sent outside the cabinet and
sent back into the room.
3. Use duct tape to make all joints secure
and air tight.
4. Refer to Figure 19. Install the non-
ducted grid by means (2) wood screws
(4.2 x 15 mm) supplied.
FIGURE 18
Ø 6"
ROUND
DUCT
FIGURE 16
Ø 8"
ROUND
METAL
DUCT
FIGURE 17
ADAPTER
FIGURE 19
- 10 -
WOOD SCREWS
(4.2 x 15 mm)