TOHATSU M 40D2 Manual Del Propietário página 59

lift up the outboard motor slightly, and
then allow gravity to lower it for you.
1
2
3
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
ENOM00069-A
Power Trim & Tilt type
Tilt up
1. Operate the Power Trim & Tilt switch
and tilt the outboard motor up.
2. Lock the tilt with the Tilt stopper after
the outboard motor has been tilted up
Tilt down
1. Release the tilt stopper from the set-up
position while slightly tilting up out-
board motor.
2. Operate the Power Trim & Tilt switch
and tilt the outboard motor down until
the motor touches to the thrust rod.
UP
DN
1
1. Tilt stopper
ENOF00059-0
The outboard motor can also be tilted up
and down using the switch provided under
the bottom cowl.
It is possible to tilt up or down in spite of
main switch "ON" or "OFF".
ENOM00940-0
Manual relief valve
If the battery is dead, and the power tilt
switch thus inoperative, open the manual
valve completely in the Manual direction.
This will allow manual tilting of the out-
board motor.
ENOF00067 2
ENOW00872-0
Make sure the manual relief valve is closed
before operating the outboard motor. If the
ENGINE OPERATION
ENOF01318-0
ENOF02358-0
WARNING
57
7