Dremel 7700 Instrucciones De Funcionamiento página 18

Use only Dremel
WARNING
this tool and may lead to personal injury or property damage.
The number and variety of accessories for the Rotary
Tool are almost limitless. There is a category suited to
almost any job you might have to do — and a variety of
sizes and shapes within each category which en ables
you to get the perfect accessory for every need.
If you expect to use a variety of accessories, we recom-
mend that in the beginning you purchase a complete
set of four collets. Store these so that you will have the
proper size of collet for any accessory or drill bit you
want to use. Currently, the 1/8", 3/32",1/32" and 1/16"
collets accommodate all of the avail able Dremel
accessories. 1/8" collets are included in most rotary
tool kits.
A mandrel is a shank with a threaded or screw head,
which are required when you use polishing acces-
sories, cutting wheels, sanding discs, and pol ish ing
points. The reason mandrels are used is that sanding
discs, cutting wheels and similar accesso ries must be
replaced frequently. The mandrel is a per manent shank,
allowing you to replace only the worn head when nec-
essary, thus saving the expense of replacing the shaft
each time.
High Speed Cutters
Available in many shapes, high speed cutters are used
in carving, cutting and slotting in wood, plastics and
soft metals such as aluminum, copper and brass. These
are the accessories to use for freehand routing or carv-
ing in wood or plastic, and for precision cutting. Made
of high quality steel. 1/8" shank.
Dremel Accessories
®
, high-performance accessories. Other accessories are not designed for
Collets
Mandrels
Screw Mandrel N° 401
This is a screw mandrel used with the felt polishing tip
and felt polishing wheels. 1/8" shank.
Small Screw Mandrel N° 402
This is a mandrel with a small screw at its tip, and is
used with emery and fiberglass cutting wheels, sanding
discs and polishing wheels. 1/8" shank.
EZ Lock Mandrel N° 402
The Dremel EZ Lock makes accessory changes easy as
PULL - TWIST - RELEASE. The one-piece mandrel
design simplifies the process of changing cutting
wheels, buffs and detail abrasive brushes (EZ Lock
compatible accessories).
Tungsten Carbide Cutters
These are tough, long-lived cutters for use on hard ened
steel, fired ceramics and other very hard ma terials. They
can be used for engraving on tools and garden equip-
ment. 1/8" shanks.
18