Identification Of Symbols On The Chainsaw; Simbols On The Machine; Symbols On The Machine - SMASH 16 Manual De Instrucciones

IDENTIFICATION OF SYMBOLS ON THE CHAINSAW

IDENTIFICATION OF SYMBOLS AND SAFETY PRECAUTIONS
Read the instruction manual before using the chainsaw.
Always use two hands when operating a chainsaw.
Read, understand and follow all the instructions.
Always wear head protection, eye protection and ear protection.
Warning! The chainsaw could kickback.

SYMBOLS ON THE MACHINE

Symbols have been engraved on the chainsaw for a safe operation and maintenance.
According to these indications, please be careful to not commit any error.
Fuel mix fill cap.
Position: Fuel cap.
Bar oil fill cap.
Position: Oil cap.
Adjusting the switch to the "O" position, the engine will stop immediately.
Position: Left back side of the unit.
Starting the engine. Pulling the air lever (at the right back side of the rear handle) towards where
the arrow points, can adjust the starting way as follows:
• CHOKE position – start up when the engine is cold.
• RUN position – normal start up.
Position: Right top side of the cover of the air´s filter.
The screw under the mark "H" is the screw to adjust the high speed.
The screw under the mark "L" is the screw to adjust the low speed.
The screw at the left side of the mark "T" is the screw to adjust the idle speed.
Position: Left side of the rear handle.
Shows the chain´s brake position (white arrow) which is the normal work position and (black arrow)
to activate the chain´s brake.
Position: In front of the chain´s cover.
51