SMASH 16 Manual De Instrucciones página 62

C – STOP THE ENGINE
1.Release the accelerator trigger to allow the engine to
be at idle speed.
c. Place the switch at "O" position (STOPPED).
D – STARTING A WARM ENGINE
When you want to turn the chainsaw on again after stopping it, move the switch to
(I) position, leave the air handle at (b) position (normal work position) and pull the
starting rope. If after several attempts it has not started, follow the starting a cold
engine steps from step nº2
E – CARBURATOR REGULATION
F – CHECKING OIL SUPPLY
1
(1)
(1) Chain oil
2
(1)
(1) Adjuster
T: Screw to adjust the
idle speed
H: Screw to adjust the high
speed.
L: Screw to adjust the low
speed.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown in
the figure. (Fig.1)
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
Adjust according to your work conditions. (Fig.2)
NOTE:
Make sure to refill the oil tank every time when
refueling the unit.
62
CAUTION:
After starting the machine and when the engine
has warmed up, the chain must not move at
idle speed. Adjust screw (T) until the chain
does not move at idle speed.Regulation of
screws H and L must be carried out by an
official after sales service dealer.
( I ) (O)