Operating The Pump; Keypad Overview; Setting A Schedule; Schedule Tables - STA-RITE VS Serie Guia De Instalacion

10

OPERATING THE PUMP

Keypad Overview

If power is connected to the pump motor, pressing any of the following buttons
referred to in this section could result in the motor starting. Failure to recognize this
could result in personal injury or damage to equipment.
1. STEP 1 (Set Schedule)
2. STEP 2 (Set Schedule)
3. STEP 3 (Set Schedule)
4. OVERRIDE (Settings)
5. START
6. STOP
Set a Schedule
If power is connected to the pump motor, pressing any of the following buttons
referred to in this section could result in the motor starting. Failure to recognize this
could result in personal injury or damage to equipment.
Set the DURATION and SPEED for the SuperFlo
Speed Pump using the keys on the User Interface. The schedule is
based on a 24-hour schedule and will repeat each day of the week.
The highest speed rating for the pump is 3450 RPM
and the lowest is 600 RPM. Unless a new user-defined
schedule is entered, the pump will operate based on the
following factory default schedule:
Button Duration
(In Hours)
STEP 1
STEP 2
STEP 3
OVERRIDE
Table 1: Factory default schedule
è DURATION and SPEED
è DURATION and SPEED
è DURATION and SPEED
è DURATION and SPEED
VS Variable
®
Speed
(In RPM)
4 2600
4 2100
4 1600
2 3100

Schedule Tables

Use the tables below to record a personalized
operating schedule. Recording the planned
schedule in the table below will make the
programming process easier and will help the
user remember the custom settings in case of
inadvertent loss of schedule. The user interface
will not allow the user to program an overlap
between different STEPs of the schedule. The
STEP currently being set will always take priority
over any previous settings. In the event a user
attempts to program with a combined duration
greater than 24 hours, the current STEP setting
will be retained whereas the other two STEP
settings will be cleared to zero hours requiring
the user to reset them. Prior to beginning the
actual programming process, it is advisable
for the user to review the planned schedule as
outlined in chart form to ensure the cumulative
duration is not greater than 24 hours and no
overlaps exist. It is always a good idea to double
check your programmed settings for accuracy
once you have completed the programming
process.
Setup #1
Step 1
Duration
Speed
Setup #2
Step 1
Duration
Speed
Table 2: Custom Schedule
Step 2 Step 3
Step 2 Step 3