Transfer Units - RK Rose+Krieger E-II Instrucciones De Montaje

7. Working life

7.2.5 Transfer units

Linear units or drives arranged in parallel or at a right angle must be matched to the transfer shaft
to transfer torques. These are installed using clamped bevel gear housings. The pins on the linear
units and the transfer unit are fitted with bevel gears. When using bevel gear drives, only units
with ball bearings should be used.
•
fix unstressed to the base
•
Observe the plug-in depth at the bevel gear housings
•
Torque clamping bolts (DIN EN ISO 4762 8.8) as instructed
Version
RK pipe system
for linear unit E-II 30
RK pipe system
for linear unit E-II 40
RK pipe system
for linear unit E-II 50
RK pipe system
for linear unit E-II 60
Electrical unit
46
Plug-in depth at
bevel gear housing
43 mm
55 mm
68 mm
80 mm
Electrical unit
DIN EN ISO 4762 8.8
Bevel gear
Transfer unit
Bevel gear housing