Berkel BF+15F Manual De Uso Y Manutención página 37

When replacing worn or damaged parts always use original spare parts to not vary
technical features. If original parts are not used the safe running of the sack filling
machine could be compromised
7.1.1 - Periodical controls
Check the hydraulic oil level in the tank every six months.
If oil is lacking the plug does not reach the limit on top and therefore top off the oil
which must have the same characterisitcs as the one indicated in the table below.
Note
The correct level of the hydraulic oil must be done with the plug completely closed
in a resting position.
7.2 - Lubrication
The machine does not need to be lubricated.
7.3 - Cleaning the machine
Disconnect the machine from the power network before cleaning it.
Do not clean the machine with a jet of water.
In particular: do not use a water cleaner.
Only use non toxic detergents, expressly destined for cleaning parts for food use.
To adequately clean the machine of mixture residue remove the cover by unfaste-
ning the locking ring nuts "4" fig. 6.2.1.
Extract the cylinder by lifting it perpendicularly to the two pins "10" and "11" fig.
6.2.1.
Clean the cylinder, plug and the external parts of the machine with water and non
toxic detergent then dry all the parts.
Reassemble everything and close it with the cover "5" with the lever "4" on the
cylinder "7" (fig. 6.2.1).
If the plug "8" must be disassembled (fig. 6.2.1) act in the following way:
-
Bring the plug to the lower limit by lifting the pedal (to block it from turning);
-
Unfasten the plug without the help of wrenches and proceed to accurately clea-
ning it.
-
Reassemble the disassembled parts by carrying out the disassembly steps in
reverse.
-
ATTENTION!
Manufacturer
AGIP
ESSO
FINA
ATTENTION!
Initials
OSO 46
NUTO H 46
HYDRAN 46
19