Sharp R-68ST-A Manual De Instrucciones página 224

To promote trouble-free use of your oven and
avoid damage.
Never operate the oven when it is empty except where
recommended in the operation manual, see Page GB-7.
Doing so may damage the oven.
When using a browning dish or self-heating
material, always place a heat-resistant insulator
such as a porcelain plate under it to prevent
damage to the turntable due to heat stress.
The preheating time specified in the dish's instructions
must not be exceeded.
Do not use metal utensils, which reflect microwaves
and may cause electrical arcing. Do not put cans in the
oven.
Use only the turntable designed for this oven.
Do not place anything on the outer cabinet during
operation.
Do not use plastic containers for microwaving if
the oven is still hot from using the GRILL, DUAL
G R I L L and A U T O M AT I C operation (except
AUTO DEFROST), because they may melt. Plastic
1. Remove all packing materials from the inside of the
oven cavity. Discard the loose polythene sheet from
between the door and cavity. Remove the feature
sticker, if attached, from the outside of the door.
✓
Remove this film
2. Check the oven carefully for any signs of damage.
3. Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked. The oven rear
surface should be placed against the wall. Do not
place the oven in a cabinet.
R-68ST-A [06_01 EN].indd 3 R-68ST-A [06_01 EN].indd 3
IMPORTANT SAFETY INSTRUCTIONS
containers must not be used during above modes unless
the container manufacturer says they are suitable.
Do not use the utensils which touch the oven cavity wall
and door during cooking. Use the utensils which turn
smoothly in the oven during cooking. Use the utensils
which are smaller than the turntable (275mm diameter).
NOTE:
If you are unsure how to connect your oven, please
consult an authorised, qualified electrician.
Neither the manufacturer nor the dealer can accept
any liability for damage to the oven or personal injury
resulting from failure to observe the correct electrical
connection procedure.
Water vapour or drops may occasionally form on
the oven walls or around the door seals and sealing
surfaces. This is a normal occurrence and is not an
indication of microwave leakage or a malfunction.
4. The oven door may become hot during
5. Do not allow the power supply cord to run
6. Ensure there is a minimum of free space above the
7. Securely connect the plug of the oven to a standard
GB-3
This symbol means that the surfaces are liable
to get hot during use.
INSTALLATION
cooking. Place or mount the oven so that
the bottom of the oven is 85 cm or more
above the floor. Keep children away
from the door to prevent them burning
themselves.
over any hot or sharp surfaces, such as
the hot air vent area at the top rear of the
oven.
oven of 18 cm.
earthed (grounded) household electrical outlet.
18 cm
7/30/09 1:39:35 PM 7/30/09 1:39:35 PM