Dispensing Hot Water; Preparing Cappuccino / Dispensing Steam; Automatic Cleaning Cycle - Caffitaly System S9001 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

ATTENTION! The hot water wand get very hot: Danger of scalding! Clean the wand with a damp
cloth after each use.
Place a metal container under the hot water wand (Fig.16).
Press the button E. Dispensing of hot water starts.
Dispensing stops when the programmed amount is reached.
Remove the container of hot water.
NB: After dispensing hot water, the system requires a pause time of 15 seconds before being able to dispense
again. If hot water is dispensed 2 times in succession, it is advisable to wait 1 minute before dispensing hot
water or steam again

Preparing cappuccino / Dispensing steam

ATTENTION! During preparation there may be some brief sprays of hot water and the steam
wand becomes very hot: Danger of scalding!
Clean the wand with a damp cloth after each use.
Place a metal container under the steam wand (Fig.17).
Press the button L; this will discharge any water remaining in the circuit.
After a few seconds, only steam will start to come out; press the button L again and empty the container.
Half-fi ll a cup with milk, then immerse the steam wand in it (Fig.17).
Press the button L to start dispensing steam.
Move the cup in a slight circular motion so that the milk is more evenly heated.
When the preparation is completed, press the button L again.
Place the cup under the desired dispenser to dispense the coff ee in the freshly frothed milk (Fig.12 or Fig.15).
NB: Whenever heating milk, to ensure correct cleaning it is advisable to dispense steam for a few seconds,
directing the steam wand inside the grille.
It is advisable to run the automatic cleaning cycle of the two groups every day. To do this, proceed as follows:
Place a large container (at least 250 ml) under the two dispensers (Fig.12 and Fig.15).
Raise the levers (N) and (P) to open the capsule compartment (Fig.4 and Fig.7).
Insert the "cleaning" capsule in the two groups, pressing it gently inside (Fig.5 and Fig.8).
Completely close the levers (N) and (P) (Fig.6 and Fig.9).
Press the buttons D and I. The machine dispenses water. Repeat the operation if the dispensed water is not clean.
Raise the levers (N) and (P) to eject the "cleaning" capsule into the special drawer (Fig.4 and Fig.7).
Close the levers (N) and (P) (Fig.6 and Fig.9).
Pull out the used capsule drawer and recover the two "cleaning" capsules (Fig.18).
34 34
English

Dispensing hot water

Automatic cleaning cycle

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido