Anti Tilting System; Duct System Tubes Connections - Lincar Mya 505 Manual Del Usuario

FUMES EXHAUST TUBES CONNECTION
This operation must be carried out by skilled personnel.
•
The appliance can be connected to the fumes exhaust tube in the following ways:
•
Vertically or on the Side or on the Rear side.
The appliance is preset by the Manufacturer with Rear connection.
For further explanation about the several connections of the Fume exhaust
•
chimney, please refer to the Instruction sheet for fume exhaust terminal
positioning attached to the appliance. The instruction sheet is to be
considered as an integral part of the Instruction Manual.

ANTI TILTING SYSTEM

The appliance is equipped with a safety device to avoid any accidental tilting.
The appliance must be mechanically secured to a plain surface or wall, fixng the
(supplied) anchors on the rear side of the appliance itself. Fixing must be steady and
safe. Assembly instructions and materials required are in the special bag.
Take the anti-tilting brackets provided with the
appliance.
Secure the brackets to the rear side of the stove by
use a screwdriver: one bracket must be secured to
the appliance, whereas the other one must be
secured to the wall, by using an anchor (Ø 8 mm)
which is suitable to the type of wall (not supplied).
Then the two brackets must be connected to each
other as shown in the figure.

DUCT SYSTEM TUBES CONNECTIONS

This operation must be carried out by skilled personnel.
•
• The duct system of the appliance can be connected in the following ways:
Front side, Side or Rear side.
The appliance is preset by the Manufacturer with Front connection.
For further explanation about the several Ducting system connections,
•
please refer to the Instruction sheet for duct system positioning attached to
the appliance. The instruction sheet is to be considered as an integral part
of the Instruction Manual.
42/128
IT-GB-FR-ES mod. 505