Maintenance Plan; Maintenance Work; Emptying The Tank - Makita VC4710 Instrucciones De Uso

Makita VC4710
6 Maintenance
6.1

Maintenance plan

7.2.1 Emptying tank
7.2.2 Emptying tank after wet suction
7.2.3 Replacing the filter bag
7.2.4 Replacing the disposal bag
7.2.5 Replacing filter element
6.2

Maintenance work

Any other maintenance than
described in chapter 6 should be
performed by Makita factory service
center.

6.2.1 Emptying the tank

After emptying the tank: clean the
rim of the tank and the seals in the
intermediate ring and the upper sec-
tion of vacuum before refitting them.
If the seal or groove is dirty or dam-
aged, the suction performance will
be reduced.
Before reinserting the suction hose:
clean the inlet fitting and hose col-
lar.
18
After finishing work


A A
A A
When required



1. Be sure that the vacuum is
switched off and unplugged.
2. Open the retaining clamps (A)
and remove the upper sec-
tion of the vacuum cleaner.
3. Tip out the collected mate-
rial.
4. The material collected must
be disposed of in accor-
dance with the applicable
regulations.
5. Attach the upper section of
the vacuum.
6. Close the retaining clamps
(B). Ensure that the retaining
clamps fit properly.
Original Instruction