Processes And Settings; Mounting Images Or Decals - SEAL 62Pro Manual De Uso

5.5

Processes and settings

5.5.1

Mounting images or decals

In this process the machine is not webbed with film.
• When mounting images onto a (pre-coated) board (B), the adhesive is on the mounting
side of the board.
• When mounting decals (A), the adhesive is on the back of the image.
The mounting process is equal for both.
1. Remove the shafts from the upper section.
2. Preset the nip and the pressure (see section 5.3.4).
3. Put the board on the in-feed table.
Figure 22: Mounting images or decals
4. Put the image on top of the board (image side up). Turn back the image at the
machine side (1).
5. Turn back approx. 25 mm (10 in.) release liner (2) at the machine side and crease this
evenly from the inside out.
Note:
The final quality depends on the way in which the leading edge of the image is applied
to the board.
Operating 37