Troubleshooting; Troubleshooting Guide; Notes - Generac OneWASH Power Washer Manual Del Operador

Ocultar thumbs Ver también para OneWASH Power Washer:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROuBleSHOOTING GuIde

PROBleM
detergent fails to mix with spray.
engine runs well at no-load but
bogs when load is added.
engine will not start; or starts and
runs rough.
engine shuts down during
operation.
engine lacks power.
CAuSe
1. Detergent siphoning tube is not submerged.
2. Detergent siphoning tube/filter is clogged or
cracked.
3. High pressure nozzle installed.
1. Engine speed is too slow.
1. Low or no oil, Indicated by a single flash on the
"Sytem Alert LED".
2. Dirty air cleaner.
3. Out of fuel.
4. Stale fuel.
5. Spark plug wire not connected to spark plug.
6. Bad spark plug.
7. Water in fuel.
8. Excessively rich fuel mixture.
9. Low or no water supply, Indicated by a double
flash on the "Sytem Alert LED".
10. Unit is on an incline greater than 15°.
1. Out of fuel.
2. Low Oil, Indicated by a single flash on the "Sytem
Alert LED".
3. Low or no water supply, Indicated by a double
flash on the "Sytem Alert LED".
4. Unit is on an incline greater than 15°.
1. Dirty air filter.

Troubleshooting

CORReCTION
1. Insert detergent siphoning tube into detergent.
2. Clean or replace filter/detergent siphoning tube.
3. Replace with low pressure nozzle.
1. Contact a local service facility to adjust throttle
mechanism.
1. Fill crankcase to proper level.
2. Clean or replace air cleaner.
3. Fill fuel tank.
4. Drain fuel tank; fill with fresh fuel.
5. Connect wire to spark plug.
6. Replace spark plug.
7. Drain fuel tank; fill with fresh fuel.
8. Contact local service facility.
9a. Turn water on and attempt to start unit. LED will
remain flashing until engine starts.
9b. Check if hose is kinked and unkink hose. LED will
remain flashing until engine starts.
10. Confirm unit is secure on level gound.
1. Fill fuel tank.
2. Fill oil to proper level.
3a. Turn water on.
3b. Check if hose is kinked and unkink hose.
4. Confirm unit is secure on level ground.
1. Replace air filter.
23

Publicidad

Tabla de contenido
loading

Tabla de contenido