Cleaning And Applying Detergent; Important; Power Washer Rinsing - Generac OneWASH Power Washer Manual Del Operador

Cleaning and aPPlying detergent

Chemicals can cause bodily injury, and/or property
‹
damage.
• NEVER use caustic liquid with power washer.
• Use ONLY power washer safe detergents/soaps. Follow all
manufacturer's instructions.
To apply detergent, follow these steps:
1. Review use of nozzles
2. Remove chemical tank cap (Figure 22).
3. Prepare detergent solution as required by job.
Figure 22 – Chemical tank & Cover
4. Insert filter on end of siphoning tube through the hole in the
chemical tank cap (Figure 23).
5. Make sure siphoning tube remains fully submerged into
detergent.
Figure 23 – install siphoning tube
Make sure the filter remains fully submerged in detergent
while applying detergent.
Contact with the hot muffler can damage detergent siphoning
tube.
NOTe:
NOTe:
• When inserting the siphon into a detergent solution bottle, route the
tube so as to keep it from inadvertently contacting the hot muffler.
6. Make sure black detergent nozzle is installed.
detergent cannot be applied with the high pressure nozzle
(Green or Red). Only use the Black nozzle with detergent.
7. Confirm set-up instructions have been followed.
you must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without the
water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction
will void warranty.
8. Start engine following instructions How to Start Your Power
Washer.
9. Apply detergent to a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlapping strokes.
10. Allow detergent to "soak in" for 3-5 minutes before washing
and rinsing. Reapply as needed to prevent surface from
drying. DO NOT allow detergent to dry on surface being
cleaned (prevents streaking).
IMPORTANT: You must flush the detergent siphoning system after
each use by placing the filter into a bucket of clean water, then run
the power washer in low pressure for 1-2 minutes.

PoWer Washer rinsing

1. Remove black detergent nozzle from lance.
2. Select and install desired high pressure nozzle following
instructions How to Use Nozzles.
3. Point spray gun in safe direction and away from people,
animals and plants. Squeeze trigger to flush any remaining
chemical from system.
4. Keep spray gun a safe distance from area you plan to spray.
kickback from spray gun can cause you to fall.
• Use only on a level surface.
• D o not use on elevated surface to prevent the risk
of a serious fall.
• Firmly grasp spray gun with both hands when using high pressure
spray to avoid injury when spray gun kicks back.
5. Apply a high pressure spray to a small area and then check
surface for damage. If no damage is found, you can assume
it is okay to continue rinsing.
6. Start at top of area to be rinsed, working down with same
overlapping strokes as you used for cleaning.
Operation
NOTe:
NOTe:
11