Propellor Installation - TOHATSU MFS 40A Manual Del Propietário

24
INSTALLATION
mended can lead to poor performance of,
and/or damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 100AH/5HR,
850 (Cold Cranking Amps (CCA), In case of
cold whether: 12V120AH/5HR (1000CCA))
Specifications and features of batteries vary
among the manufacturers. Consult the
manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the outboard
motor.
5
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery, and
then connect the negative lead (—).
W h e n d i s c o n n e c t i n g t h e b a t t e r y
always remove the negative lead (—)
first. After connecting the positive ter-
minal (+), securely place a cap on it to
prevent short circuits.
1. Battery cord (red)
2. Battery cord (black)
2
1
ENOF00022-0
ENOM00045-A
4. Propeller installation
ENOW00085-A
WARNING
Do not begin propeller removal and instal-
lation procedure with spark plug caps
attached, shift in forward or reverse, main
switch at other than "OFF", engine stop
switch lock attached to the switch, and
starter key attached, or engine could acci-
dentally start leading to serious personal
injury.
Disconnect battery cable if possible.
ENOW00085-0
WARNING
Do not hold propeller with hand(s) when
loosening or tightening propeller nut. Put a
piece of wood block between propeller
blade and anti-ventilation plate to hold pro-
peller.
ENOW00086-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
ENOF00084-B