Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8. AIR CONDITIONER USE
1. DESCRIZIONE DEI COMPONENTI
8.1 Air conditioner start-up
- Make sure about the right electrical supply of the air conditioner
- By pushing the light button
switched off).
- By pushing ON/OFF button on the remote control the light turns off
and the air conditioner starts working.
Air conditioner now starts working in the following ways:
- Cooling, blue
light turned on
- Dehumidifier, blue
light turned on
- Fan, no lights turned on
B
A
- Heating, orange
light turned on
Attention!
O N
O F F
For correct reception of signals by the indoor unit, the remote control
should be pointed towards it.
Avoid having obstructions between the remote control and the receiver
on the indoor unit.
If the remote control is installed on the wall, it should be close to the
O N
O F F
indoor unit.
The remote control should not be:
- Allowed to get wet
- Dropped
- Exposed to the direct sun light
- Exposed to heating sources
Fluorescent lights and cordless phones can upset the operation of the
remote control. If this happens, move closer to the air conditioner.
Sending the signal to the air conditioner automatically, you will hear a
beep and the display will temporarily show the symbol
Models Dual / Trial
All internal units have to start working in the same way.
Attention!
To safeguard the correct functioning of the compressor a delayed start has
been built in.
Even if requested immediately, the next startup will occur only after three
minutes.
the red light is turned on (unit is
B
A
.
CLOCK
BLOW
TURBO
BIP
AUTO
MODE
FAN
I FEEL
TIMER ON
TEMP
SLEEP
LIGHT
GB
GB
63
Publicidad
Tabla de contenido
