Bosch VAC090S Instrucciones De Funcionamiento página 10

BM 2610027608 10-13_VAC090 VAC140 2/6/14 4:10 PM Page 10
FIG. 7
HOSE PORT
V CUUM HOSE
Wet Vacuuming notes:
• The heavy-duty slurry bags can be used
when vacuuming wet materials. They are
ideally suited for slurry-suction applications.
• The paper bags should not be used when
wet vacuuming because the water will cause
the bag to come apart.
• The plastic bags should not be used when
wet vacuuming because the bag may tear
when removed if it is fully loaded with liquid.
• See WET VACUUMING section for more
information.
Semi
C UTION
cleaning and automatic
filter cleaning must be turned off when
using paper bags. The reversal of air during
filter cleaning may damage the paper bag.
InStallInG a DuSt BaG
1. Unlock the canister latches and remove the
control unit.
2. Grasp a new dust bag at the flange. Push it
over the internal dust port first and then over
the raised ring. Make sure the entire flange
is seated in the recessed area of the internal
dust port. Make sure that the dust bag is not
folded over on itself and the full length of the
bag faces the front and bottom of the
canister.
3. For plastic bags only – After the plastic bag
has been attached to the internal dust port,
wrap the upper edges of the plastic bag over
automatic filter
-10-
all four sides of the rim at the top of the
canister. Make sure that the plastic bag
does not interfere with the canister latches.
4. Re-attach the control unit.
5. Lock the canister latches.
remoVInG tHe DuSt BaG
1. Unlock the canister latches and remove the
control unit.
If a plastic bag is used:
2. Align the top of the plastic bag. Peel the
cover off the adhesive strip and fold over
onto the plastic bag to seal the top closed.
3. Remove the plastic bag from the internal
dust port by pulling the bag towards the rear
of the canister.
4. Remove the bag from the canister and twist
the top of the bag.
5. Tie off the plastic bag below the port
opening and dispose of properly.
If a paper, fleece, or slurry bag is used:
1. Remove the bag from the internal dust port
by pulling the flange towards the rear of the
canister.
2. Pull the tab on the flange up until the
opening has been closed off by the paper
cover.
3. Remove the bag from the canister and
dispose of properly.
FIG. 8
HOSE PORT
DISPOS L B G