Bosch VAC090S Instrucciones De Funcionamiento página 14

BM 2610027608 10-13_VAC090 VAC140 2/6/14 4:10 PM Page 14
emptyInG tHe CanISter
(models VaC090a & VaC090S only)
1. Switch the unit off.
2. Disconnect from the power supply.
3. Open the canister latches.
4. Remove control unit.
5. Remove the filter bag; dump out the canister,
or drain out the canister as appropriate.
emptyInG tHe CanISter
(models VaC140a & VaC140S only)
1. Switch the unit off.
2. Disconnect from the power supply.
3. Position vacuum in area where the contents
of the canister can be drained.
4. Detach drain hose from stored position on
vacuum and lay hose on the ground (Fig.
13).
5. Once canister is emptied, secure drain hose
and allow canister to air dry.
CanISter maIntenanCe
Wipe out the canister from time to time with a
commercially available, non-scouring cleaning
agent and allow to dry.
preventive maintenance
W RNING
must be performed by a
Bosch factory Service Center or autho-
rized Bosch Service Station. Service
performed by unauthorized personnel may
result in misplacing of internal wires and
components which could cause serious
injury.
tool luBrICatIon
Your Bosch tool has been properly lubricated
and is ready to use.
Cleaning
to avoid accidents always
W RNING
disconnect the tool from
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most effectively with compressed
maintenance
Service
FIG. 13
dry air. always wear safety goggles when
cleaning tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
See also the
CLEANING OF THE FILTER CARTRIDGES,
CLEANING THE MOTOR PROTECTION
FILTERS, WATER-LEVEL
MAINTENANCE
MAINTENANCE.
Certain cleaning agents
C UTION
and
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia
detergents that contain ammonia.
-14-
sections THOROUGH
SENSOR
and CANISTER
solvents damage
and household