Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Configuration
(Standalone)
Sound-Active
Mode
Sound Sensitivity
Auto Mode
Master/Slave
Mode
IR Wireless
Control
Scorpion™ Dual User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
Never connect a product that is operating in any standalone mode (Auto or
Sound-Active) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Sound-Active program, do the following:
1.
Press <MENu> repeatedly until Sou (Sound-Active) or Aut (Auto) blinks on the
display.
2.
Use <UP> or <DOWN> to select Sound-Active.
Press <ENTER>.
3.
To set the sound sensitivity, follow the instructions below:
1.
Press <MENU> repeatedly until S 0—S 9 blinks on the display.
2.
Use <UP> or <DOWN> to select the desired sound sensitivity.
Press <ENTER>.
3.
The product will only respond to low frequencies of music (bass and drums).
The laser will blackout when in Sound-Active mode after 3 seconds of silence or
noise below the sensitivity setting.
To enable the auto mode, follow the instructions below:
1.
Press <MENU> repeatedly until Sou (Sound-Active) or Aut (Auto) blinks on the
display.
2.
Use <UP> or <DOWN> to select Auto program.
3.
Press <ENTER>.
The Master/Slave mode allows a single Scorpion™ Dual product (the master) to control
the actions of one or more Scorpion™ Dual products (the slaves) without the need of a
DMX controller. The master will be set to operate in either Auto mode or Sound-Active
mode, while the slaves will be set to operate in Slave mode. Once set and connected,
the slaves will operate in unison with the master.
Configure the products as indicated below.
Slaves:
1.
Press <MODE> repeatedly until SLA shows on the display.
Press <ENTER>.
2.
3.
Connect the DMX input of the first slave to the DMX output of the master.
4.
Connect the DMX input of the subsequent slaves to the DMX output of the previous
slave.
5.
Finish setting and connecting all the slaves.
Master unit:
1.
Set the master to operate in either Auto mode or Sound-Active mode.
2.
Make the master the first unit in the DMX daisy chain.
Configure all the slave units before connecting the master unit to the DMX
·
daisy chain.
Never connect a DMX controller to a DMX string configured for Master/Slave
·
operation because the controller may interfere with the signals from the
master unit.
·
Do not connect more than 31 slave units to the master unit.
To enable IR wireless control, follow the instructions below:
1.
Press <MENU> repeatedly until rEN shows on the display.
2.
Press <ENTER>.
Page 19 of 64
Publicidad
Tabla de contenido
