Connect Rain/Freeze Sensor (Optional) - Rain Bird ESP-Me Manual Del Usuario

Connect Rain/Freeze Sensor (optional)

ENG
The ESP-Me controller can be set to obey or ignore a
rain sensor. Refer to the Rain Sensor section under
Advanced Programming.
A
Remove the yellow jumper wire from the SENS
terminals on the controller.
b c
NOTE: Do not remove the yellow jumper wire
unless connecting a rain sensor.
B
Connect both rain sensor wires to the SENS
terminals, as shown.
c c
WARNING: Do not route the rain sensor wires
through the same opening as the power wiring.
b c
NOTE: Rain Bird controllers are only compatible
with normally closed rain sensors.
b c
NOTE: For wireless rain/freeze sensors, refer to
installation instructions for sensor.
10
ESP-Me Controller
B