Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Try to operate the actuator and check that it works with the logic above described. If the logic is reversed, it is necessary
to delete all the codes stored (read Switch 3) and start again the above procedure.
To add another transmitter TX2 to the control unit it is necessary to use a remote control previously stored (TX1) and
proceed as follows:
a)
R6-CONTROL only: press several times the key SELC of the transmitter TX1 until displayed the channel stored (by the
leds).
b)
R6-CONTROL only: press several times the key SELC of the new transmitter TX2 until display the channel to be stored (by the
leds).
c)
Take the actuator to half its way with TX1.
d)
Set to ON the switch 1 of the transmitter TX1.
e)
Press and keep pressed for about 5 seconds the key PROG of the TX1 until the motor starts to move.
f)
Release the key PROG, the motor stops.
g)
Press the key UP or DOWN of the TX2: the transmitter is stored with the same logic of the TX1.
3.2 Switch 3: deletion of all the stored transmitters
To delete all the transmitters stored on the control unit it is necessary using a remote control previously stored and
proceed as follows:
a)
Power only the control unit to be programmed.
b)
R6-CONTROL only: press several times the button SELC on the transmitter until displayed the channel stored (by
the leds).
c)
Position the actuator at the mid-stroke.
d)
Set on ON the switch 3 of the transmitter.
e)
Press and keep pressed the button PROG of the transmitter until the motor moves in both the ways for 1 second,
showing the end of deletion.
f)
Release the button PROG and set on OFF the switch 3 of the transmitter.
19
Publicidad
Tabla de contenido
