Ethernet Interface - Weidmuller THM Basic 300 Instrucciones Para El Manejo

7.3

Ethernet interface

Implementation of THM Basic 300 into the Network, transmission of the IP address to the printer
1 Save the file "weidmuelleripswitch.exe" on the desktop and open the IP switch tool with a double click.
2 Connect the printer and the PC with LPT or USB port and turn the THM Basic 300 on.
Connection with LPT
1 Choose LPT 1 and click on "Configure". Select the right port of the parallel port settings and confirm it.
Figure 8
2 Enter in the new IP address from your administrator and if required the data of "New subnet mask" and
"New gateway". Please confirm and transmit the new IP data to the THM Basic 300 printer with "Update".
3 A self-test with the THM Basic 300 shows you whether the data transfer was successful or if you have to
do it twice. On the print you can see the actual "IP address", "New subnet mask" and "New gateway" of
the printer. For the self-test please press and hold "Cancel" until all LED's start to flash and then press
"Pause".
Make sure that you inserted a big label for this test in the THM Basic 300 printer.
4 Please restart the process from point 1, if the self-test shows you that the IP data transfer wasn't success-
ful. For the restart it is necessary to turn the printer of and after a view seconds on again.
1168670000/02/08.11
Interfaces
53