Seasonal Stoppages; Maintenance Review; Operation Of The Display; General Information Of The Display - Bio Bronpi Berta Instrucciones De Instalación, Uso Y Mantenimiento

7.8

SEASONAL STOPPAGES

If the stove is not going to be used for a long time, it is advisable to leave the fuel tank empty, such as the screw-type conveyor to avoid the
fuel compacting. Clean the stove and the smoke duct, removing the ashes and others residues, close the stove door. It is recommended to
clean the chimney at least once a year. Meanwhile, check the seals because if they are not in good condition (they do not seal the door), they
do not guarantee the proper operation of the stove! For this reason, it would be necessary to change them. If there is humidity in the place
where the stove is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral Vaseline in order to keep the
appearance overtime.
7.9

MAINTENANCE REVIEW

It is also advisable to check and clean, at least once a year, the existent ashes reservoir on the stove. These operations should be done
exclusively by an authorised technician.
Please, bear in mind that the stove could need to be cleaned more than once during a season of usage. This depends on the quality of the
fuel used, the smoke installation, and the proper regulation of the stove.
In the following table (also attached to your stove in the fuel tank cover) you can check the frequency of the maintenance tasks and who must
do it.
CLEANING TASKS
Remove the burner from the chamber and clean the holes with the use of the poker provided. Remove the ash with
a vacuum-cleaner.
Hoover the ashes which are inside the burner place.
Operate the scrapers doing a movement from down to up several times. (**Only models provided of its)
Empty the ash pan or vacuum the ash compartment when necessary.
Vacuum the bottom of the pellet tank when necessary.
Clean the internal of the combustion chamber descale in the walls with a correct vacuum cleaner.
Clean the smoke extractor fan, the whole combustion chamber, pellet tank, whole replacement of the seals and
put again silicone where necessary, smoke duct, reservoirs...
Check all the electronic components (electronic board, display...)
Check all the electrical components (resistance, smoke extractor fan, circulator pump).
8

OPERATION OF THE DISPLAY

8.1

GENERAL INFORMATION OF THE DISPLAY

The display shows information about the stove performance.
Depending on the working mode, the display may have different meanings depending on the position of
the leds lighten.
Drawing D19 shows an example of a stove switched off.
8.2

FUNCTIONS OF THE DISPLAY'S BUTTONS

Description
Pressing
3 seconds
O-RING
Pressing
1 second
O-RING
Rotating
O-RING
8.3

USER MODE

Below is a description of the display normal operation according to the available functions.
Before the ignition of the stove, the display shows the following screen (see drawing D20).
8.3.1

IGNITION OF THE STOVE

In order to ignite the stove, press the display button for 3 seconds. The successful ignition is shown on
the screen with the blinking of the 4 quadrants, as shown on drawing D21.
The maximum length of the ignition phase is 25 minutes. After this time, if there is no visible flame, the
stove will automatically go into an alarm state.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Function Performance description
RESET ALARMS In case of alarm it cancels the alarms and switch off the stove
ON/OFF On / Off the stove
Fan control The exchanger fan speed might be controlled.
Bigger / Smaller power Increase and decrease the working power depending on the necessities
20
√
√
√
√
√
√
√ √
√ √
√ √
1
Blue
D19
Red
Blue
D20
Red
MOD. BERTA
√
√
√
√
√
√