Seasonal Stoppages; Maintenance Review; Operation Of The Remote Control / Display; General Information Of The Remote Control / Display - Bio Bronpi NEVA Instrucciones De Instalación, Uso Y Mantenimiento

D43
8.9

SEASONAL STOPPAGES

If the stove or insert is not going to be used for a long time it is advisable to keep the fuel tank empty, such as the screw-type conveyor
to avoid the fuel compacting. Clean the stove and the smoke duct, removing the ashes and other residues and close the stove door. It is
recommended to clean the chimney at least once a year. Meanwhile, check the seals because if they are not in good condition (they do not
adjust to the door), they do not guarantee the proper operation of the stove! For this reason, it would be necessary to change them. If there
is humidity in the place where the stove or insert is installed, put absorbent salts inside the equipment. Protect the internal parts with neutral
vaseline in order to keep the appearance overtime.
8.10

MAINTENANCE REVIEW

It is also advisable to check and clean COMPULSORY once a year, the existing ashes registers in the bottom and
the top part of the stove.
Your stove has a preventive maintenance notice established after 1200 hours of operation, which will remember
you the need of cleaning the registers of your stove. These operations should be done exclusively by an
authorised technician.
This message is not an alarm, but a reminder or warning. Therefore, it will allow you to use the stove while this
message is shown in the display.(see drawing D47).
Please, bear in mind that the stove could need to be cleaned before this 1200 hours established by default or
even after them. This depends on the quality of the fuel used, the smoke installation, and the proper regulation
of the stove.
In the following table (also pasted on your stove in the fuel tank cover) you can check the frequency of the
maintenance tasks and who must do it.
CLEANING TASKS
Remove the burner from the chamber and clean the holes with the use of the poker provided. Remove the ash with
a vacuum-cleaner.
Hoover the ashes which are inside the burner place.
Operate the scrapers doing a movement from down to up several times. (**Only models provided of its)
Empty the ash pan or vacuum the ash compartment when necessary.
Vacuum the bottom of the pellet tank when necessary.
Clean the internal of the combustion chamber descale in the walls with a correct vacuum cleaner.
Clean the smoke extractor fan, the whole combustion chamber, pellet tank, whole replacement of the seals and
put again silicone where necessary, smoke duct, reservoirs...
Check all the electronic components (electronic board, display...)
Check all the electrical components (resistance, smoke extractor engine, circulator pump).
9

OPERATION OF THE REMOTE CONTROL / DISPLAY

9.1

GENERAL INFORMATION OF THE REMOTE CONTROL / DISPLAY

The remote control shows information about the stove performance. Once you access to the menu, you will see different screens and
configurations depending on the level.
Depending on the working mode, the display may has different meanings depending on the position in the screen.
Image D48 shows an example of when the stove or insert is off.
Image D49 shows the layout of the messages during the programming or configuration of the working parameters. Particularly:
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D44
D46
35
D50
D45
END
HOURS
MENU
√
√
√
√
√
RADIOFREQUENCY SERIES
D47
√
√
√
√
√
√ √
√ √
√ √
√ √